The serpentine belt used within the Honda V6 engine, which Honda put in in autos just like the Honda Civic and Honda pilot, runs all of the equipment on the automobile. These equipment embody the power steering pump, alternator, air conditioner and water pump. When the belt wears out, it can not run the equipment on the price wanted. Honda put in a tensioner pulley however as a result of tight house, you will need to jack the front of the Honda off the bottom and entry the pulley from below the car.
Honda V6 Serpentine Belt Installation Instructions
Draw a diagram of the pulleys on the Honda V6 and denote in your diagram which side of the pulleys the belt pushes in opposition to. Find the tensioner pulley near the underside of the engine. The pulley has a sq. gap within the face of it. Once more, you need to entry the pulley from beneath the automobile, on the passenger side of the engine.
Place the 3/8-inch ratchet driver into the opening within the pulley and push up on the deal with. This releases pressure on the belt. Pull the belt off the tensioner pulley.
Remove the belt from the remaining pulleys and raise the outdated belt out of the engine bay. Full this step from the engine bay and never from under the car.
Place the brand new belt into the engine bay and route the belt round all of the pulleys besides the tensioner pulley. Use your diagram as a information. Get below the Honda V6 once more, push up on the ratchet driver deal with and safe the belt over the tensioner pulley.
[taken from ehow.com]
